Tip Use Necklace-Determine the type of necklace / bracelet desired
-Approximate length / circumference bracelet adults:
Small / Medium = 18 cm-19cm, Medium Large = 20-2 1cm.
Children: Small = 11-13cm. Medium = 15cm
But if you want to make the appropriate size, you can measure your wrist circumference, and add 1.5-2cm. This figure is the length of bracelet you want. Specify the termination end of a series of techniques and cover you want to use (clasp). In general, cover necklace / bracelet with a split ring has a length of 1.5 to 2.5 cm when installed, depending on the size of the clasp that you use.
- At the termination technique with a crimp bead without bead tip, add up to 7cm long rope from the length you want. (desired necklace length - the length of clasp + 7 cm). Suppose the desired length = 43cm. Clasp = 2cm long. Wire required is 43cm - 2 cm + 7 cm = 48 cm. 7 cm is the tolerance required for the termination process as in the technique necklace B.3. Some go back into the series, and partly cut in the stage of completion. Figures for this tolerance would be minimized if you are already quite adept at this technique.
- At the termination technique with a bead tip, measuring the results of a series of bead Tip - clasp - beadtip. (The average size of my designs take up to 2.5 cm). Subtract this measure from the length you want. Add 1 to 1.5 cm, from the size you get. For example: the desired length of necklace = 43cm, length bead tip - clasp - bead tip = 2.5 cm. The length of wire needed = 43 to 2.5 + 1.5 = 42 cm. 1 to 1.5 centimeters is tolerance that is given to replace the long rope inside the bead tip and is wasted.
-Approximate length / circumference bracelet adults:
Small / Medium = 18 cm-19cm, Medium Large = 20-2 1cm.
Children: Small = 11-13cm. Medium = 15cm
But if you want to make the appropriate size, you can measure your wrist circumference, and add 1.5-2cm. This figure is the length of bracelet you want. Specify the termination end of a series of techniques and cover you want to use (clasp). In general, cover necklace / bracelet with a split ring has a length of 1.5 to 2.5 cm when installed, depending on the size of the clasp that you use.
- At the termination technique with a crimp bead without bead tip, add up to 7cm long rope from the length you want. (desired necklace length - the length of clasp + 7 cm). Suppose the desired length = 43cm. Clasp = 2cm long. Wire required is 43cm - 2 cm + 7 cm = 48 cm. 7 cm is the tolerance required for the termination process as in the technique necklace B.3. Some go back into the series, and partly cut in the stage of completion. Figures for this tolerance would be minimized if you are already quite adept at this technique.
- At the termination technique with a bead tip, measuring the results of a series of bead Tip - clasp - beadtip. (The average size of my designs take up to 2.5 cm). Subtract this measure from the length you want. Add 1 to 1.5 cm, from the size you get. For example: the desired length of necklace = 43cm, length bead tip - clasp - bead tip = 2.5 cm. The length of wire needed = 43 to 2.5 + 1.5 = 42 cm. 1 to 1.5 centimeters is tolerance that is given to replace the long rope inside the bead tip and is wasted.